MSM7xx Controllers Configuration Guide v6.4.0

6. The Network Tree will no longer be visible. The Summary box will show Teaming with a
blinking gray status light. This indicates that the controller is searching for a team.
On controller 1, do the following:
1. Select Controller >> Management > Teaming.
2. Select the Controller teaming checkbox.
3. Under Connectivity, set Establish control channel on to LAN port.
4. Select No VLAN.
5. Select the Team manager checkbox, and configure the following settings under it:
• Set Team name to a name that identifies the team. This example uses 1st Floor. The team
name provides a convenient way to identify a team.
• Set Team management IP address to the virtual IP address that will be used to provide
access to the team manager. This example uses the address 192.168.1.99.
• Set Mask to 255.255.255.0.
Note: If the Team IP address is on the same subnet as the physical address assigned to
the selected Interface, then you must set Mask to match the IP mask set on the physical
interface. This applies even if the physical interface is set to act as a DHCP client.
• Set Interface to LAN port. This makes the Team IP address available on the LAN port.
6. Select Save.
7. Controller 2 and 3 will now attempt to discover the manager. Monitor the Summary box until
you see two Unauthorized controllers in the list.
Indicates team manager is synchronized.
Indicates team manager and two new controllers were detected.
Indicates team manager is configured.
Indicates two new controllers have been discovered.
252 Controller teaming