MSM7xx Controllers Configuration Guide v6.4.0

DescriptionDiagnostic
The controller configuration is being reset to factory defaults. This is normal and
will occur when the software version on the manager is changed or if the controller
is not synchronized.
Resetting configuration
The controller is currently restoring its previous configuration settings.Restoring configuration
The controller had its software and configuration settings successfully updated
by the team manager and is fully operational.
Synchronized
The controller cannot be added because the team already has the maximum
number of supported members. To add the controller you must first remove one
or more team members.
Unconfigurable
The product type of the controller is not supported on this team. All controllers
must have the same product type as the team manager.
Unsupported product
Configuration settings are currently being sent to the controller.Uploading configuration
The team manager is uploading new software to the controller. Wait until the
operation completes.
Uploading firmware
The capabilities of the controller are being identified by the team manager.Validating capabilities
The team manager is waiting for the controller to send its configuration.Validating configuration
The team manager is waiting for the controller to send its software version number.Validating firmware
The controller has been authorized by the team manager. However, the controller
has not yet decided to join this team. (If multiple managers replied to the controller
discovery request, the controller may choose to connect with a different team.)
Waiting for acceptance
• Action: Indicates the recommended administrative action to be taken to resolve a diagnostic
condition.
Viewing team members
To display information about controllers that are members of the team, select Controllers >> Overview
> Team members.
Team members are controllers that fall into one of the following categories:
• The controller was discovered on the network, authorized by an administrator, and successfully
joined the team at least once.
• The controller was manually added to the team by selecting Add New Controller on the
Overview > Configured controllers page.
Select the title of a column to sort the table according to the values in the column.
266 Controller teaming