MSM7xx Controllers Configuration Guide v6.4.0

For example:
Number of team members required to support redundancy
APs / 200
Number of APs you
want to deploy
N + 3N + 2N + 1
432.6120
4321200
5432400
-542.2440
-542.6520
-543600
--54800
Another way to look at it is as follows:
Maximum APs you can deploy to ensure redundancy
Maximum AP licenses
that can be installed
Number of team
members
N +3N + 2N + 1
--2004002
-2004006003
2004006008004
4006008008005
NOTE: A team supports a maximum of 800 APs and 5 team members.
Primary team manager failure
The controller that is designated as the team manager on the Controllers > [team-manager ] >>
Management > Teaming page is called the primary team manager.
If the primary team manager becomes inoperative, an interim team manager is automatically
selected by the existing team members. The interim manager assumes the team IP address and all
management functions until the primary team manager returns, with the following limitation: the
interim manager cannot modify the configuration or update the firmware for members. This is done
to avoid the situation where configuration changes made by interim manager are undone by the
primary manager when it comes back online.
When an interim manager is active, the Teaming status light in the Summary box will be yellow.
All configurable settings on the menus in the right pane will be grayed out. Status information
however, will be visible.
272 Controller teaming