MSM7xx Controllers Configuration Guide v6.4.0

5. Select Save.
Configure controller #3 and #4
1. Start the management tool each independent controller by pointing your browser to appropriate
IP address.
2. Select Management > Device discovery.
3. Select Mobility controller discovery.
4. Set IP address of the primary mobility controller to 192.168.1.99.
5. Select Save.
You can now configure wireless mobility options, as explained in “Mobility traffic manager”
(page 285).
Multiple teamed and non-teamed controllers
If you have multiple teams with or without multiple non-teamed controllers, mobility support is
configured as follows: Choose one team as the primary mobility controller. On all other
teams/non-teamed controllers set the IP address of primary mobility controller parameter to the
team IP address of the primary mobility controller.
Guest access and teaming
Caution: When using teaming and deploying a guest access solution, you must not use the Create
a wireless network for guests workflow. Instead, you must manually configure guest access as
described in the section “Guest access and teaming” (page 276).
The guest access feature (public access interface) provides a way for a controller to act as the
gatekeeper between two network segments: a public network connected to the LAN port (Access
network on the MSM720), and a protected network connected to the Internet port (Internet network
on the MSM720). Access to the public network and its resources is usually made available to all
276 Controller teaming