MSM7xx Controllers Configuration Guide v6.4.0

• Configure mobility settings for each VSC. (The same VSCs must be defined on all controllers
in the mobility domain, even on controllers that are not managing any APs.)
• Bind VSCs to the APs.
Each task is described in more detail in the sections that follow.
Defining the mobility domain
When MTM will be used on more than one controller, or with a controller team, you must define
a mobility domain. The following instructions apply to non-teamed controllers. If you are working
with a controller team, see “Mobility support” (page 273).
Connect to the management tool on the controller that will be the primary mobility controller, and
do the following:
1. Select Controller >> Management > Device discovery.
• Select Mobility controller discovery.
• Select This is the primary mobility controller.
On the MSM720
On other controllers
2. Select Save.
Connect to the management tool on all other controllers, that will be part of the mobility domain
and do the following:
1. Select Controller >> Management > Device discovery.
2. Select Mobility controller discovery.
3. Specify the IP address of the primary mobility controller. This can be the address of any port
as long as the port is reachable. For example, if the primary is at 192.168.5.1, you would
configure the other controllers as follows:
On the MSM720
Configuring Mobility Traffic Manager 291