MSM7xx Controllers Configuration Guide v6.4.0

Network profiles
This scenario uses the default network profiles, so no configuration is necessary.
VSC binding
This scenario assumes that all APs are part of the Default Group. Set the egress for the group to
the Internet port on the controller.
1. Select Controller > Controlled APs > Default Group >> VSC bindings and then select HP. The
VSC binding page appears.
• Under VSC Profile, set VSC profile to HP.
• Select Egress network, and under it, set Network profile to LAN port network.
2. Select Save.
Scenario 2: Centralized traffic on a controller with VLAN egress
This scenario illustrates how to centralize the traffic from a VSC that is deployed on several APs
on different subnets and send it to one or more VLANs via the controller. (On an MSM720, replace
LAN port with Access network and Internet port with Internet network in the following descriptions.)
How it works
In this scenario, a single controller manages several APs deployed on different subnets. The default
VSC (named HP) is assigned to each AP and is used to provide wireless services for users. All
traffic on this VSC is tunneled to the controller by MTM, where it is egressed onto the wired network
on VLAN 40. To accomplish this, the egress network in the VSC binding is set to a network profile
that defines a VLAN on the controller Internet port.
Scenario 2: Centralized traffic on a controller with VLAN egress 301