MSM7xx Controllers Configuration Guide v6.4.0

3. Under Map To, select Internet port.
4. Select Save.
VSC binding
This scenario assumes that all APs are part of the Default Group.
1. Select Controlled APs > Default Group >> VSC bindings and then select HP. The VSC binding
page appears.
• Under VSC Profile, set VSC profile to HP.
• Select Egress network, and under it set Network profile to All-Traffic.
2. Select Save.
Scenario 3: Centralized traffic on a controller with per-user traffic routing
This scenario illustrates how to centralize the traffic from a VSC that is deployed on several APs
on different subnets and send it to different VLANs for different groups of users. (On an MSM720,
replace LAN port with Access network and Internet port with Internet network in the following
descriptions.)
How it works
In this scenario, a single controller manages several APs deployed on different subnets. The default
VSC (named HP) is assigned to each AP and is used to provide wireless services for users. All
traffic on this VSC is tunneled to the controller by MTM, where it is egressed onto different VLANs
for different user groups.
An account profile is created for each user that define the egress VLAN for their traffic. This profile
is then associated with the users account.
304 Mobility traffic manager