MSM7xx Controllers Configuration Guide v6.4.0

9. Select Add New Interface to open the Add/Edit interface page.
10. Under Interface, select the network profile that you defined earlier.
11. Under Assign IP address via, select the addressing method to use.
• DHCP client: Dynamic host configuration protocol. The DHCP server will automatically
assign an address to the network profile, which functions as a DHCP client.
• Static: Specify an IP address, Mask, and Gateway.
12. Enable/disable NAT support if required.
13. Select Save. The new interface is added to the IPv4 interfaces table.
To assign an IP address to a new interface on other controllers
Any network profile that has a VLAN ID and is mapped to a physical port can have an IP address
assigned to it. The following steps illustrate how to create a new profile and assign an IP address
to it.
1. Select Controller >> Network > Network profiles.
2. Select Add New Profile.
36 Network configuration