MSM7xx Controllers Configuration Guide v6.4.0

Supported on VSCs that are ...DescriptionPCM setting
Requires that the Bandwidth control
feature is enabled on the controller
mapped to the user account as
follows:
(Controller >> Network > Bandwidth
6, 7 = VERY-HIGH
control) when access-controlled VSCs
are used.
4, 5 = HIGH
0, 2 = NORMAL
1, 3 = LOW
Access controlledSets the users ingress and egress data
rates in bytes.
Ingress/Egress rate limit
Access controlledSets a custom access control list for
the user.
Network resources access rule
Important
When using PCM to configure settings in a user's RADIUS account, you should not use Colubris
AV-Pair values to define other settings in the same account. Standard RADIUS attributes can be
used however.
User attribute definitions
The following attributes are supported for user accounts.
Accounting RequestAccess AcceptAccess Request
• Acct-Authentic• Acct-Interim-Interval• Acct-Session-Id
• Called-Station-Id • Acct-Delay-Time• Chargeable User Identity (CUI)
• Class• Calling-Station-Id • Acct-Event-Timestamp
• Acct-Session-Id• EAP-Message• CHAP-Challenge
• CHAP-Password • Acct-Status-Type• Idle-Timeout
• Reply-Message• Chargeable User Identity (CUI) • Calling-Station-Id
• Called-Station-Id• Session-Timeout• Connect-Info
• EAP-Message • Chargeable User Identity (CUI)• Termination-Action
• Tunnel-Medium-Type• Framed-IP-Address • Class
• Framed-IP-Address• Tunnel-Private-Group-ID• Framed-MTU
• NAS-Identifier • NAS-Identifier• Tunnel-Type
448 Working with RADIUS attributes