MSM7xx Controllers Configuration Guide v6.4.0

For information on VPN address pool, see “Configure an IPSec profile for wireless client VPN”
(page 509).
Configuring the global DHCP server
The global DHCP server can be used to automatically assign IP addresses to devices that are
connected to the controller via the LAN port or through the client data tunnel. If you do not have
a DHCP server operating on your network, you can use the global DHCP server to assign addresses
to your wired clients, wireless clients, and controlled APs.
For added flexibility, separate DHCP servers can be enabled on any access-controlled VSC,
enabling different address ranges to be served. For details, see “DHCP server” (page 134).
NOTE:
• Do not enable the DHCP server if the LAN port (Access network on the MSM720) is connected
to a network that already has an operational DHCP server.
• The global DHCP server settings are always used by the default VSC.
• The DHCP server feature is not supported when controller teaming is active.
To configure the global DHCP server
1. Select Controller >> Network > Address allocation.
2. Select DHCP server and then Configure.
Configuring DHCP services 45