MSM7xx Controllers Configuration Guide v6.4.0

Acct-Output-Gigawords
(32-bit unsigned integer)
High 32-bit value of the number of octets/bytes sent by the user. Only present when
Acct-Status-Type is Interim-Update or Stop. As defined in 2869.
Acct-Output-Octets
(32-bit unsigned integer)
Low 32-bit value of the number of octets/bytes sent by the user. Only present when
Acct-Status-Type is Interim-Update or Stop.
Acct-Output-Packets
(32-bit unsigned integer)
Low 32-bit value of the number of packets/bytes sent by the user. Only present when
Acct-Status-Type is Interim-Update or Stop.
Accounting stop only
Acct-Terminate-Cause
(32-bit unsigned integer)
Termination cause for the session See RFC 2866 for possible values. Only present when
Acct-Status-Type is Stop.
NotesCauseID
Supported. Indicates that the user logged out.User Request1
Supported. Indicates that the client station is no longer alive.Lost Carrier2
Supported. When location-aware is enabled and a user switches
access points, the controller re-authenticates the user. If authentication
fails due to timeout, this code is returned.
Lost Service3
Supported. User exceeded the idle timeout value defined for the
session.
Idle Timeout4
Supported. User exceeded maximum time defined for the session.Session Timeout5
Supported. User session was terminated by the controller
administrator via SNMP or the management tool.
Admin Reset6
Not Supported. (not applicable)Admin Reboot7
Supported. If two users are detected using the same IP address, both
are logged out with this error. Another cause is if an error is
Port Error8
encountered in an access list definition. For example, an invalid host
was specified.
Not Supported. (not applicable)NAS Error9
Not Supported. (not applicable)NAS Request10
Supported. User was logged out because the controller was restarted.NAS Reboot11
Not Supported. (not applicable)Port Unneeded12
Supported. When a user switches AP or SSID with incompatible
configurations (authentication type), they are logged out with this
code. Also if the user changes authentication type of the same AP.
Port Preempted13
Not Supported. (not applicable)Port Suspended14
Not Supported. (not applicable)Service Unavailable15
Not Supported. (not applicable)Callback16
Supported. An 802.1X client initiated a second authentication request
for a user, and this request was refused.
User Error17
456 Working with RADIUS attributes