MSM7xx Controllers Configuration Guide v6.4.0

login-url=https://srv2.abc.com/loginpage.html
welcome-url=http://srv2.abc.com/mywelcome.html
• If both servers are down, then the URLs are not changed.
Redirect URL
The redirect-url value is used to specify the target URL for redirection when using an access list with
the REDIRECT action. Only one redirect-url value can be specified in each controller or user RADIUS
account.
When an access list rule with the REDIRECT action is processed, the users browser is redirected
to a different HTTP address in this order:
• redirect-url keyword in the user account, if present
• redirect-url keyword in the controller account, if present
• login-url keyword, in the controller account, if present
The URL can contain any of the applicable placeholders defined here.
NOTE: Placeholders %G, %C, %E, %P, and %v do not produce constant values. These values may
vary over time.
Use the following Colubris AV-Pair value string:
redirect-url=URL_of_the_page [placeholder ]
Where:
DescriptionParameter
URL of the redirect page. Access to the Web server hosting this page must be granted to all
unauthenticated users. Do this with an appropriate access list definition.
URL_of_the_page
The following placeholders can be added to the redirect-url string.
DescriptionPlaceholder
Returns the IP address of the users computer.%c
Returns the URL on the controller where user login information should be posted for
authentication. By default, this value is URL encoded. (To enable/disable URL encoding, set
the value of url-encode in the <ACCESS-CONTROLLER> section in the configuration file.)
%l
Returns the NAS ID assigned to the controller. By default, this is the unit serial number. Not
supported in local mode.
%n
Returns the RADIUS login name assigned to the controller. By default, this is the unit serial
number. Not supported in local mode.
%s
Returns the original URL requested by the user. By default, this value is URL encoded. (To
enable/disable URL encoding, set the value of url-encode in the <ACCESS-CONTROLLER>
section in the configuration file.)
%o
Returns the domain name assigned to the controller Internet port.%i
Returns the port number on the controller where user login information should be posted to
for authentication.
%p
Returns the IP address of the controller interface that is sending the authentication request.%a
When the location-aware feature is enabled, returns the ESSID of the wireless access point
the user is associated with.
%E
When the location-aware feature is enabled, returns the wireless mode ("ieee802.11a",
"ieee802.11b", "ieee802.11g") the user is using to communicate with the access point.
%P
Colubris AV-Pair - Site attribute values 479