MSM7xx Controllers Configuration Guide v6.4.0

Where:
DescriptionParameter
Specify the name of an existing access list. This list is
activated for the current user.
uselistname
Advertising
Add this keyword to enable the presentation of advertising at preconfigured intervals while the
user is browsing.
Syntax
ads-presentation=value
Where:
DescriptionParameter
Set this to 1 to activate the display of advertising. Set
to 0 to disable.
value
Bandwidth level
This keyword sets bandwidth level for a users session. The actual data rate associated with a
bandwidth level is defined on the Network > Bandwidth control page. See “Bandwidth levels”
(page 52). To control the default bandwidth level for all users, see “Default user bandwidth level”
(page 473).
Syntax
bandwidth-level=level
Where:
DescriptionParameter
Specify one of the following the bandwidth levels for
the users session:
level
VERY-HIGH
HIGH
NORMAL
LOW
Data rate
This keyword sets the transmit and receive rates for a users session. These rates are applied on a
per-user basis providing direct control of a users throughput in Kbps. Two keywords are available:
• max-input-rate: Controls the data rate at which traffic can be transferred from the user to the
controller.
• max-output-rate: Controls the dcata rate at which traffic can be transferred from the controller
to the user.
NOTE: The settings for bandwidth level always take precedence over user data rates. This means
if you set a data rate which exceeds the configured bandwidth level, the rate is capped at the
bandwidth level.
Colubris AV-Pair - User attribute values 485