MSM7xx Controllers Configuration Guide v6.4.0

Where:
DescriptionParameter
For packets: 32-bit unsigned integer value.value
For octets: 64-bit unsigned integer value.
When a user session is terminated based on a quota, a new non-standard termination cause is
used. The value for this termination cause is 0x8744.
The text value of for the termination cause is defined in the message.txt file under the token
"stat-quota-exceeded". The default value for this token is "Logged out. (Quota Exceeded.)". This
value can be displayed with the ASP function GetAuthenticationErrorMessage().
A series of ASP functions are available that enable you to display quota information on the session
page. See Session quotas.
Redirect URL
The redirect-url keyword is used to specify the target URL for redirection when using an access list
with the REDIRECT action. Only one redirect-url value can be specified in a user RADIUS account.
See “Redirect URL” (page 479).
SMTP redirection
The controller is able to provide SMTP email service on a per-user basis. This enables users to send
e-mail while on the road without the restrictions imposed by most ISPs regarding the source address
of outgoing mail. It works by intercepting the call to a users e-mail server and redirecting it to an
SMTP server that you configure. This setting overrides the setting of “Default user SMTP server”
(page 475).
NOTE: For mail redirection to work, the user's email server name must be publicly known. If the
e-mail server name cannot be resolved, mail redirection fails.
NOTE: If an access list definition is active in the controller profile that enables unauthenticated
users to access their SMTP servers, the SMTP redirect feature will not work for these users.
Syntax
smtp-redirect=address[:port][,username, password]
Where:
DescriptionParameter
Specify the IP address or domain name of the e-mail
server which is used to send outgoing redirected mail.
address
Specify the port on the e-mail server to relay to. Range:
1 to 65535. Default: 25
port
Specify the username required to log on to the SMTP
server. Maximum 32 characters.
username
Only supported if the Support authentication on SMTP
proxy server option is enabled on the Public access >
Access control page. Works with SMTP servers that
support PLAIN, CRAM-MD5, and no authentication.
Specify the password required to log on to the SMTP
server. Maximum 32 characters.
password
Only supported if the Support authentication on SMTP
proxy server option is enabled on the Public access >
Colubris AV-Pair - User attribute values 487