MSM7xx Controllers Configuration Guide v6.4.0

Placeholders
• %RN: System name of the neighboring device to which the port is connected, obtained via
the System Name TLV. Since this is an optional TLV, if it is not available, the Chassis ID
TLV is used instead.
• %RP: Port description of the port on the neighboring device to which the local port is
connected, obtained via the Port Description TLV. Since this is an optional TLV, if it is not
available, the Port ID TLV is used instead.
• %SN: The AP serial number.
• %IP: The AP IP address. An IP address can require up to 15 characters (nnn.nnn.nnn.nnn).
Application type profiles
Application type profiles are used to define configuration settings which can be applied to the
Application Type field in a Network Policy TLV on an HP 517 or MSM317 switch port.
The Network Policy TLV enables the HP 517 or MSM317 switch port to send configuration
information to voice devices such as IP phones. To enable use of the Network Policy TLV, select
Controlled APs >> Configuration > Switch ports > [HP 517 or MSM317] > [ switch-port ].
Application type
This release only supports the Voice application type.
VLAN ID
Specify a VLAN ID for this profile. This VLAN will be assigned to the switch port.
VLAN tagging
• Tagged: The VLAN is tagged.
• Untagged: The VLAN is untagged.
L2 priority
Select the layer 2 priority setting. This setting is used instead of the Default traffic priority set
for the switch port. Supported settings are:
QoS
queue
L2 priority
4Low - 1
Low - 2
3Normal - 0
Normal - 3
2High - 4
High - 5
1Very high - 6
Very high - 7
DiffServ
This value only applies if VLAN tagging is set to Tagged.
Configuring LLDP on an AP 525