MSM7xx Controllers Configuration Guide v6.4.0

MIB support
The following MIBs are supported:
• sFlow-MIB base OID: 1.3.6.1.4.1.14706
• SNMP MIB2 System base OID: 1.3.6.1.2.1.1
• SNMP MIB2 Interfaces base OID: 1.3.6.1.2.1.2 Note: The ifType OID of the SNMP MIB2
Interfaces will have the value 71 (ieee802.11) for the wireless interfaces.
• SNMP MIB2 IPAddrTable base OID: 1.3.6.1.2.1.4.20
• SNMP MIB2 ifXTable base OID: 1.3.6.1.2.1.31.1.1.1
• SNMP MIB: HP-WLAN-SFLOW-EXTENSIONS-MIB base OID: 1.3.6.1.4.1.11.2.14.11.6.4.2
Configuring and activating sFlow
All sFlow configuration occurs via the controller management tool by selecting Controller >> Tools
> sFlow.
IMPORTANT: Under normal conditions, sFlow settings on the controller will be configured by an
sFlow collector operating elsewhere on the network. Therefore, in most cases all you need to do
to support sFlow is select the Enabled option under Global settings.
Advanced users who want to fine tune their sFlow configuration, or who are using an sFlow collector
in manual mode, can select Advanced Configuration to gain access to additional settings.
Manual configuration of sFlow will not work with PCM, and other collectors may require special
configuration to operate in this manner.
Status light
Indicates the state of the sFlow proxy.
• Red: sFlow is disabled.
• Yellow: sFlow is enabled and is in the process of starting up.
• Green: sFlow is ready.
Global settings
Enabled
Turns sFlow support on. Once enabled, sFlow agents will be activated on all controlled APs,
and the agents will appear in the Active sFlow agents list. To see this list, select Advanced
Configuration.
528 sFlow