MSM7xx Controllers Configuration Guide v6.4.0

Disabled
Turns sFlow support off.
Advanced configuration
Select this button to define advanced sFlow configuration settings. Advanced configuration
settings are not persistent. They are lost after a restart and are not saved when doing a
configuration backup.
MIB version
Version number of the supported sFlow-MIB.
Management address
This is the IP address that a collector will use to configure sFlow. It is usually the LAN port IP
address (Access network on the MSM720), or the Team IP address on a controller team.
NOTE: SNMP must be enabled on this port hosting the management address.
sFlow enabled interfaces
Displays the number of sFlow interfaces that are enabled.
To enable an interface, select Advanced Configuration.
Advanced sFlow configuration
This page provides access to all sFlow configuration settings, including those on controlled APs.
(Configuration settings for the sFlow agents operating on an AP are also available by selecting
the AP in the Network Tree and then selecting Tools > sFlow.)
Once sFlow support is enabled, sFlow agents will be activated on all controlled APs, and the agents
will appear in the Active sFlow agents list.
Collectors
Up to three collectors can be configured. To configure a collector, select its name in the list. Once
configured, collectors can be assigned to receive data from the sampling instances for any active
sFlow agent.
The table lists the following information for each collector.
• Name: Name used to identify the collector.
• IP address: IP address of the collector. This is the address to which the controller will send
sFlow data.
• Timeout: The time (in seconds) that the collector maintains ownership of a sampling instance.
Configuring and activating sFlow 529