MSM7xx Controllers Configuration Guide v6.4.0

3. Under Protocol, from the drop-down list select TCP.
4. Under Start port, from the drop-down list select SIP. Start port and End port are automatically
populated with the correct value: 5060.
5. Under Priority, from the drop-down list select Very High.
6. Select Save.
NOTE: You could also create another profile using the same parameters but for UDP to cope
with any kind of SIP traffic.
7. On the IP QoS Profile page select Add New Profile.
8. Under Profile name, specify Web.
9. Under Protocol, from the drop-down list select TCP.
10. Under Start port, from the drop-down list select http. Start port and End port are automatically
populated with the common HTTP port, 80.
11. Under Priority, from the drop-down list select Low.
12. Select Save.
Assign the profiles to a VSC
1. In the Network Tree, select VSCs, and then select one of the VSC profiles in the Name column.
Scroll down to the Quality of service section in the Virtual AP box.
2. Under Quality of service, set Priority mechanism to IP QoS.
IP QoS 67