MSM7xx Controllers Configuration Guide v6.4.0

Radio configuration parameters
This section provides definitions for all configuration parameters that are present on all products.
Regulatory domain
Indicates the geographical region in which the AP is operating. To set the regulatory domain, see
Assigning country settings to a group (page 170).
Operating mode
Select the operating mode for the radio. Available options are:
Access point and Local mesh: Standard operating mode provides support for all wireless
functions. (Not supported on radio 3 on the MSM335.) The total available bandwidth on the
radio is shared between all local mesh links and wireless users. This can result in reduced
throughput if lots of traffic is being sent by both wireless users and the local mesh links. You
can use the QoS feature to prioritize traffic.
Access point only: Only provides AP functionality, local mesh links cannot be created. (Not
supported on radio 3 on the MSM335.)
Local mesh only: Only provides local mesh functionality. Wireless client stations cannot connect.
Monitor: Disables AP and local mesh functions. Use this option for continuous scanning across
all channels in all wireless modes. See the results of the scans by selecting Controlled APs >>
Security > Neighborhood.
Sensor: Enables RF sensor functionality on the radio. HP APs are smart APs, and do not forward
broadcast packets when no client stations are connected. Therefore, the RF sensor function
will not be able to detect these APs unless they have at least one connected wireless client
station. This feature requires that the appropriate license is installed on the AP. See “Managing
licenses (page 541).
The following table shows the operating modes supported for each product.
SensorMonitorLocal mesh onlyAccess point only
Access point and
Local mesh
Product
MSM310
nl
MSM310-R
MSM320
nl
MSM320-R
MSM325
MSM335
nl
(Radio 1 + 2)
MSM335
nl
(Radio 3)
MSM410
MSM422
MSM317
HP 425
MSM430
MSM460
Radio configuration 87