MSM7xx Controllers Release Notes v6.2.0.1

NOTE: Due to a problem with AP channel use validation, a banner similar to this may appear at
the top of the Home screen: AP CNxxxxxxxx, Radio 1 channel configuration has been
set to autochannel because the previously configured channel Auto is not
supported by this version of software. The same message is added to the system log.
These messages can be safely ignored.
Software configuration change may be required prior to upgrade
If the MSM7xx Controller is configured with the NAT feature enabled (default setting) and with the
Extend VSC egress subnet to VSC ingress subnet feature enabled (disabled by default), the v6.2.0.0
software will disable the NAT feature. It is recommended that you review your existing settings and
disable one of these features before upgrading to v6.2.0.0.
Updating software
Update the controller software as described in the “Software updates” section of the MSM7xx Controllers
Configuration Guide. Once the controller is updated, it automatically updates all of its controlled
devices to the same software version.
Downgrading software
If you upgrade to version 6.2.0.0 and then wish to return to the version that you had been running
prior to upgrading, the configuration that you used originally with that version will still be available.
If you have made configuration changes while using version 6.2.0.0, those changes will not be present
when you downgrade to the previous version.
If you factory reset your device after upgrading to version 6.2.0.0, your previous configurations will
be lost, and when you downgrade to any previous version you will be in a factory reset state.
MSM management tool now requires web browser with SSLv3 support
NOTE: A web browser that supports SSLv3 is mandatory for running the MSM web-based management
tool. SSLv3 is supported by Microsoft Internet Explorer 7 and 8 but must be enabled. Microsoft Internet
Explorer 9 only uses SSLv3. Mozilla Firefox also supports SSLv3 but support may need to be enabled
or you may need to update to a more recent version.
New HP MSM775 zl Premium Controller
Added support for the MSM775 zl Premium Controller. For more information, see the HP MSM775
zl Controller Quickstart and the HP MSM775 zl Controller Installation Guide.
The MSM775 zl Premium Controller requires MSM software v6.2.0.0 or later.
New HP 425 802.11n Access Point
Added support for the HP 425 Dual Radio 802.11n Access Point (Worldwide: JG654A, Americas:
JG653A, Japan: JG655A, Israel: JG656A). Note: The HP 425 only operates in controlled mode. See
the HP 425 802.11n Access Point Quickstart.
To support the HP 425, MSM7xx Controllers require at least MSM software v6.2.0.0.
MSM710 Controller support stops at v6.0.x
Support for the discontinued MSM710 Controller is available in software versions prior to v6.2.x. As
of v6.2.0.0, support for the MSM710 is dropped.
Note: The HP 425 is not supported by the MSM710 Controller.
4 Software configuration change may be required prior to upgrade