AB378A Fibre Channel Mass Storage Adapter Installation Guide, December 2006

Fibre Channel Adapter Installation for OpenVMS
Additional Configuration Information
Chapter 2
22
Additional Configuration Information
NOTE OpenVMS supports Point-to-Point or Direct Fabric Attach topology. Public loop or arbitrated
loop is currently not supported.
Review the Guidelines for OpenVMS Cluster Configurations located at:
http://www.hp.com/go/openvms/doc
for additional information about configuring and booting Fibre Channel devices on OpenVMS.
LED Interpretation
Table 2-3 AB378A LED Interpretation Table
HBA State
Yellow
LED
(4 Gbps)
Green
LED
(2 Gbps)
Amber
LED
(1 Gbps)
Comments
Power OFF OFF OFF OFF Card doesn’t have power
Power ON ON ON ON Card powered on and not initialized
Power ON 1 Flash/s 1 Flash/s 1 Flash/s After firmware initialization AWAITING LINK-UP
All flashing at the same time
Firmware
Fault
2 Flash/s 2 Flash/s 2 Flash/s All three LEDs flash in continuous sequence
1 Gbps Link
UP/ACT
OFF OFF ON
5 Flash/s
ONLINE
IO Activity
2 Gbps Link
UP/ACT
OFF ON
5 Flash/s
OFF ONLINE
IO Activity
4 Gbps Link
UP/ACT
ON
5 Flash/s
OFF OFF ONLINE
IO Activity