AB378A Fibre Channel Mass Storage Adapter Installation Guide, December 2006

Fibre Channel Adapter Installation for HP-UX

Installing Adapter Hardware

Chapter 1

• Ensure that the system is grounded.

• Open the system to gain access to the PCI backplane.

• Insert the card into the highest-performance PCI-X slot available.

NOTE With HP-UX 11i v2, be sure to check that you are installing the card in a

non-switched slot. If you install the card in a switched slot, you will see the following

error message:

fcd [hardware path]: HBA installed on unsupported slot

If you see this message, you must shut down the system, remove the card, and

re-install it in a non-switched PCI-X slot. Refer to the server documentation for

instructions on how to identify a non-switched PCI-X slot.

Step 2. Install the card

• Slide the adapter edge-connector into the PCI-X slot until it is fully seated.

• Secure the card and reassemble the system.

Figure 1-1 AB378A Single Port Fibre Channel Adapter and Port WWN