AB378A Fibre Channel Mass Storage Adapter Installation Guide, February 2007
Table Of Contents
- AB378A Fibre Channel Mass Storage Adapter Installation Guide
- 1 Fibre Channel Adapter Installation for HP-UX
- Prerequisites
- Important Patches and Updates
- Installing Driver Software
- Installing Adapter Hardware
- Attaching the Adapter to Other Fibre Channel Devices
- Verify the Fibre Channel Adapter Installation
- LED Interpretation
- Obtaining Card Information after Installation
- Verifying Connectivity
- Interpreting Legacy Hardware Paths (HP-UX 11i v1 and 11i v2)
- Interpreting Lunpath Hardware Paths (HP-UX 11i v3)
- Components of Lunpath Hardware Paths
- Fibre Channel
- 2 Fibre Channel Adapter Installation for OpenVMS
- Prerequisites
- Installing Driver Software
- Installing Adapter Hardware
- Attaching the Adapter to Other Fibre Channel Devices
- Verifying the Fibre Channel Adapter Installation
- Additional Configuration Information
- LED Interpretation
- A Technical Specifications and Regulatory Information
Fibre Channel Adapter Installation for OpenVMSLED InterpretationChapter 226Review the Guidelines for OpenVMS Cluster Configurations located at:http://www.hp.com/go/openvms/docfor additional information about configuring and booting Fibre Channel devices on OpenVMS.LED InterpretationTable 2-2 AB378A LED Interpretation TableHBA StateYellowLED(4 Gbps)GreenLED(2 Gbps)AmberLED(1 Gbps)CommentsPower OFF OFF OFF OFF Card doesn’t have powerPower ON ON ON ON Card powered on and not initializedPower ON 1 Flash/s 1 Flash/s 1 Flash/s After firmware initialization AWAITING LINK-UPAll flashing at the same timeFirmwareFault2 Flash/s 2 Flash/s 2 Flash/s All three LEDs flash in continuous sequence1 Gbps LinkUP/ACTOFF OFF ON5 Flash/sONLINEIO Activity2 Gbps LinkUP/ACTOFF ON5 Flash/sOFF ONLINEIO Activity4 Gbps LinkUP/ACTON5 Flash/sOFF OFF ONLINEIO Activity
- Interpreting Lunpath Hardware Paths (HP-UX 11i v3)