AB379A Fibre Channel Mass Storage Adapter Installation Guide, February 2007

Fibre Channel Adapter Installation for HP-UX

Verifying Connectivity

Chapter 1

Engineering Date Code : A-4602

Part Serial number : US00016362

Misc. Information : PW=15W;PCI=66MHZ;PCI-X=266MHZ

Mfd. Date : 4602

Mfd. ID : FC2410401-10 04

Check Sum : 0xc5

EFI version : 01.01

ROM Firmware version : 04.00.70

BIOS version : 01.06

FCODE version : 01.12

Asset Tag : NA

Example of ioscan entry after installation

fc 0 0/0/2/1/0 fcd CLAIMED INTERFACE HP AB379-60001 4Gb Dual Port PCI/PCI-X Fibre

Channel Adapter (FC Port 1)

/dev/fcd0

fc 1 0/0/2/1/1 fcd CLAIMED INTERFACE HP AB379-60001 4Gb Dual Port PCI/PCI-X Fibre

Channel Adapter (FC Port 2)

/dev/fcd1

fcp 0 0/0/2/1/1.97 fcd_fcp CLAIMED INTERFACE FCP Domain

ext_bus 2 0/0/2/1/1.97.5.19.0 fcd_vbus CLAIMED INTERFACE FCP Array Interface

target 11 0/0/2/1/1.97.5.19.0.0 tgt CLAIMED DEVICE

disk 11 0/0/2/1/1.97.5.19.0.0.0 sdisk CLAIMED DEVICE HP OPEN-9

/dev/dsk/c2t0d0 /dev/rdsk/c2t0d0

disk 14 0/0/2/1/1.97.5.19.0.0.1 sdisk CLAIMED DEVICE HP OPEN-9

/dev/dsk/c2t0d1 /dev/rdsk/c2t0d1

disk 18 0/0/2/1/1.97.5.19.0.0.2 sdisk CLAIMED DEVICE HP OPEN-9

/dev/dsk/c2t0d2 /dev/rdsk/c2t0d2

disk 21 0/0/2/1/1.97.5.19.0.0.3 sdisk CLAIMED DEVICE HP OPEN-9

/dev/dsk/c2t0d3 /dev/rdsk/c2t0d3

Verifying Connectivity

Once your HP Fibre Channel Mass Storage software and hardware is installed and running, follow these

steps to verify connectivity:

Step 1. Check the state of all Fibre Channel hardware and interfaces. Enter the ioscan command and

verify that the Hardware State and the HW-Interface State are CLAIMED.

If the Fibre Channel device file has not been created, enter the following commands:

# insf -e

# ioscan -f