HP BLc QLogic 4X QDR InfiniBand Managed Switch and InfiniBand Switch Management Module Installation Guide for HP c-Class BladeSystems
Table Of Contents
- Contents
- Preparing for Installation
- Hardware Installation
- Installing an HP BLc QLogic 4X QDR InfiniBand Managed Switch
- Installing InfiniBand Cables in an HP BLc QLogic 4X QDR InfiniBand Managed Switch
- Removing an InfiniBand Cable from the HP BLc QLogic 4X QDR InfiniBand Managed Switch
- InfiniBand Subnet Management
- Hardware Removal
- Regulatory Compliance
- Installation of Switch Management Module

18 Regulatory Compliance
This compliance is indicated by the following conformity marking placed on the product:
Hewlett-Packard GmbH, HQ-TRE, Herrenberger Strasse 140, 71034 Boeblingen, Germany
The official EU CE declaration of conformity for this device may be found at
http://www.hp.com/go/certificates
Japanese Notice
Korean Notice
T his m arking is valid for no n-Teleco m prod ucts
and EU harmonized Telecom p ro ducts (e.g. Bl uet oot h).
xxxx*
This marki ng is valid for EU non -harm onized Telecom product s .
*Notified bod y num ber (used on ly if ap plicable - refer to the p ro duct label)
JAPANESE NOTICE
この装置は、クラスA情報技術装置です。この装置を家庭環境で使用すると電
波妨害を引き起こすことがあります。この場合には使用者は適切な対策を講ず
るよう要求されることがあります。
VCCI-A