HP 501 Wireless Client Bridge V1.0.0.0 Configuration and Administration Guide

Configuring SNMP 17
To remove a configured SNMPv3 user, select the name in the SNMPv3 user list, and then click
Remove.
Configuring SNMPv3 receivers
The HP 501 can send SNMP traps to configured SNMPv3 users. The eligible users must be
configured on the SNMPv3 users page. On the SNMPv3 receivers page, you provide IP
information for the users you select to receive traps.
To configure an SNMPv3 receiver:
1. In the management tool, select Management > SNMPv3 receivers.
2. In the IPv4/IPv6 address field, enter the IP address where the trap will be sent.
3. In the Port box, enter the logical UDP port number to associate with SNMP receiver
messages.
4. From the Users list, select the user to associate with this IP address and port, and then click
Add. You can add up to eight receivers.
5. When you are finished adding receivers, click Save.
To remove a configured SNMPv3 receiver, select the name in the SNMPv3 receiver list, and
then click Remove.
Supported MIBs
The HP 501 supports the following MIBs and MIB objects:
Standard MIBs
The following standard MIBs are supported:
• BRIDGE-MIB (802.1d) • SNMP-USM-DH-OBJECTS-MIB
• ENTITY-MIB (RFC 2737) • SNMPv2-CONF
• IANAifType-MIB • SN M Pv 2- M I B ( R F C 2418 )
• IEEE802dot11- M IB • SNMPv2-SMI
• IF-MIB • SNMPv2-TC