HP 501 Wireless Client Bridge V1.0.0.0 Configuration and Administration Guide

A Resetting to factory defaults
Factory reset procedures
To force the HP 501 into its factory default state, follow the procedures in this section.
Caution Resetting the HP 501 to factory defaults deletes all configuration settings, resets the manager
user name and password to admin, and enables the DHCP client on the Ethernet port. If no
DHCP server assigns an address to the HP 501, its address defaults to 192.168.1.1.
Using the reset button
Insert a tool such as a paper clip into the Reset button hole, and press and hold the reset button
for a few seconds until the status LEDs flash three times.
Using the management tool
To reset the HP 501 to factory defaults:
1. Launch the management tool (default https://192.168.1.1).
2. Select Maintenance > Config file management.
3. In the Reset section, click Reset.