HP 517 802.11ac Unified Walljack Configuration Guide v6.4.0

must be assigned to the controller port to ensure that user traffic is properly routed from the HP
517 to the VSC on the controller.
Key configuration settings for Port 2 are as follows:
Configuration of the VLAN on the controller is done by defining a network profile with VLAN 10
and binding it to the LAN port on the controller. Define the new network profile on the Controller
>> Network > Network profiles page and assign VLAN 10 to it.
Map the new network profile to the LAN port using the Controller >> Network > VLANs page.
Because the VLAN is only used to route traffic to the appropriate VSC on the controller, it does not
require an IP address.
Port configuration page 33