HP 517 802.11ac Unified Walljack Configuration Guide v6.4.0

Binding to a non-access-controlled VSC
When a port is bound to a non-access-controlled VSC, the controller is used for authentication
tasks only. Authentication can occur by checking the user's MAC address or via 802.1X. Access
control must then be performed by another device on the network, or not at all.
Example 1. Binding to a specific VSC
If deploying this scenario using an MSM720, the switch is connected to port 1, 2, 3, or 4 on the
MSM720.
On all other controllers, the switch is connected to the LAN port on the controller.
In this scenario, Port 2 is bound to the VSC named Guest. Since this is a non-access-controlled
VSC, the port is mapped directly to the VSC ingress on the controller with the Ethernet switch
38 Configuring the switch ports