MSM7xx Controllers Release Notes v6.4.0.0

• AddSubscriptionPlan

• DeleteSubscriptionPlan

• DeleteAllSubscriptionPlans

• UpdateSubscriptionPlanName

• UpdateSubscriptionPlanOnlineTimeState

• UpdateSubscriptionPlanValidityPeriodState

• UpdateSubscriptionPlanOnlineTime

• UpdateSubscriptionPlanValidityPeriodMethodState

• UpdateSubscriptionPlanValidityPeriodFor

• UpdateSubscriptionPlanValidityPeriodBetween

• UpdateSubscriptionPlanValidityPeriodFrom

• UpdateSubscriptionPlanValidityPeriodUntil

• UpdateSubscriptionPlanBooleanAttribute

• UpdateSubscriptionPlanIntAttribute

• UpdateSubscriptionPlanBandwidthLevelAttribute

Note on SOAP function UpdateUserAccountRemovalSettings

The Removal due to invalidity option of this function works in a teaming environment. However, the

Removal due to inactivity option should be avoided when teaming because it could cause the controllers

to wrongly remove active accounts.

Fixes

Version 6.4.0.0 includes fixes to the following issues:

• The AP is not sending LLC SNAP frames to the switch when a wireless client associates.

• (Applies to teaming with Country set to Russia.) The controller team does not synchronize when

any of these channels are manually selected:

149, 153, 157, 161

• (Applies to teaming.) APs fail to find the team member controller when using DNS discovery

• (Applies to teaming.) Network Address Translation (NAT) is not applied to traffic on an

access-controlled VSC with an egress VLAN defined, when the wireless client connects through

a team member controller.

• RF Manager 6.7 does not recognize the HP 425 Access Point as an HP branded device.

Information about the HP 425 being adopted by the controller is sent to RF Manager, but the

information does not get into the RF Manager authorized AP list.

• Wireless user authentication requests are not shared between Active Directory trusted domains.

• Rate limiting does not work in the downstream direction for any VSC that uses a VLAN for egress.

• After an upgrade, APs may become unsynchronized and not resynchronize when Automatic

Power Control for APs is enabled.

• If you have more than five VLAN interfaces with IP addresses, the controller can experience issues

at boot time.

• The "GetAuthenticatedusers" SOAP command provides erroneous results for bytes sent and bytes

received.

Fixes 15