KB.15.15

Example 6 show IPv6 command output

HP Switch(tunnel-3)# show ipv6

Internet (IPv6) Service

IPv6 Routing : Enabled

ND DAD : Enabled

DAD Attempts : 3

VLAN Interfaces

Interface Name : DEFAULT_VLAN

IPv6 Status : Disabled

Layer 3 Status : Enabled

Interface Name : VLAN22

IPv6 Status : Enabled

Layer 3 Status : Enabled

Address | Address

Origin | IPv6 Address/Prefix Length Status

---------- + ---------------------------------- ---------

autoconfig | fe80::218:71ff:feb9:8500/64 tentative

Tunnel Interfaces

Interface Name : TUNNEL3

IPv6 Status : Enabled

Layer 3 Status : NA

Address | Address

Origin | IPv6 Address/Prefix Length Status

---------- + --------------------------------—- ---------

autoconfig | fe80::218:71ff:feb9:8500/64 tentative

Syntax:

show ipv6 nd

Displays the current IPv6 ND settings on the configured VLAN interfaces.

start here

“show IPv6 nd output with default settings” (page 23) shows the output on a switch having

IPv6 enabled on VLANs 1 and 22.

Example 7 show IPv6 nd output with default settings

HP Switch# show ipv6 nd

IPV6 Neighbor Discovery Configuration

Interface DAD RCH Time NS Interval

Name Attempts (msecs) (msecs)

--------- --------- ---------- -----------

1 3 30000 1000

22 3 30000 1000

Syntax:

show ipv6 vlan [ vlan vid | tunnel tunnel-id ]

Viewing the current IPv6 addressing configuration 23