IPv6 Configuration Guide K/KA/KB.15.15

Example 166 Output for show ipv6 ospf3 link-state area-scope advertise
HP Switch# show ipv ospf3 link-state area-scope advertise area 1 router-id
1.0.0.4
OSPFv3 Area Scope Link State Database for area 0.0.0.1
Raw Advertisements
------------------------------------------------------------------------
0e60200100000000010000048000000583f0002801000013020000010000027800000278
0fff9b01
0e382003000000060100000480000003167d002400000001400000002620000f00000000
0e3820030000000e010000048000000393fa002400000002400000002620000b00000000
0e3820040000000d010000048000000351ad002000000013000000010f010102
0e6a20090000000001000004800000056b57003400012001000000000100000480020000
Viewing OSPFv3 link-state link-scope information
The commands in this section enable display of the routing-switch's OSPFv3 link-state link-scope
database, with options for narrowing the scope of the output and increasing the range of settings
included in the output.
Syntax:
show ipv6 ospf3 link-state link-scope interface vlan-id
lsid lsid-# router-id rtr-id-# [ detail | advertise ]
Displays link-state link-scope database for all links configured on the routing switch.
The range of displayed data can be reduced by using one or more subset options:
interface vlan-id
Subset option to filter displayed LSA database or advertisements to show only
the link-scope data from a specific VLAN.
Can also be filtered with other subset options (lsid and router-id) to further
define the source of displayed information.
lsid lsid-#
Subset option to filter displayed LSA database or advertisements to show only
the link-scope data having the specified (32-bit) IP address as a link-state ID.
Can also be filtered with other subset options (router-id and interface)
to further define the source of displayed information.
router-id rtr-id-#
Subset option to filter displayed LSA database or advertisements to show only
the link-scope data having the specified router-ID.
Can also be filtered with other subset options (lsid and interface) to further
define the source of displayed information.
detail
Displays additional details for each LSA included in the range of displayed
LSAs for any of the above options.
advertise
Displays the hexadecimal data in LSA packets (advertisements) within the
OSPFv3 link scope on the routing switch.
The output can also be filtered by lsid and router-id.
To display link-scope link-state information, enter show ipv6 ospf3 link-state link-scope
at any CLI level. When you enter this command, an output similar to the following is displayed:
Viewing a summary of OSPFv3 configuration information 241