KB.15.15

config filename

Copies the contents of a file on a remote host to a configuration file on the

switch.

flash [ primary | secondary ]

Copies a software file stored on a remote host to primary or secondary

flash memory on the switch. To run a newly downloaded software image,

enter the reload or boot system flash command.

pub-key-file

Copies a public-key file to the switch.

startup-config

Copies a configuration file on a remote host to the startup configuration

file on the switch.

oobm

For switches that have a separate OOBM port, specifies that the transfer will

be through the OOBM interface. (Default is transfer through the data interface.)

Syntax:

copy source

tftp ipv6-addr filename [ pc | unix ] [ oobm ]

Copies (uploads) a source data file on a switch that is enabled with TFTP server

functionality to a file on the TFTP server at the specified IPv6 address, where source

is one of the following values:

command-output cli-command

Copies the output of a CLI command to the specified file on a remote host.

config filename

Copies the specified configuration file to a remote file on a TFTP server.

crash-data [ slot-id | master ]

Copies the contents of the crash data file to the specified file path on a remote

host. The crash data is software-specific and used to determine the cause of a

system crash. You can copy crash information from an individual slot or from

the master crash file on the switch.

crash-log [ slot-id | master ]

Copies the contents of the crash log to the specified file path on a remote host.

The crash log contains processor-specific operational data that is used to

determine the cause of a system crash. You can copy the contents of the crash

log from an individual slot or from the master crash log on the switch.

event-log

Copies the contents of the Event Log on the switch to the specified file path on

a remote host.

flash [ primary | secondary ]

Copies the software file used as the primary or secondary flash image on the

switch to a file on a remote host.

startup-config

Copies the startup configuration file in flash memory to a remote file on a TFTP

server.

running-config

Copies the running configuration file to a remote file on a TFTP server.

Transferring TFTP files over IPv6 47