KB.15.15

Example 27 show snmp-server command output with IPv6 address

HP Switch(config)# show snmp-server

SNMP Communities

Community Name MIB View Write Access

-------------------- -------- ------------

public Manager Unrestricted

marker Manager Unrestricted

Trap Receivers

Link-Change Traps Enabled on Ports [All] : All

Traps Category Current Status

---------------------------- ---------------

SNMP Authentication : Extended

Password change : Enabled

Port-Security : Enabled

Authorization Server Contact : Enabled

DHCP-Snooping : Enabled

Dynamic ARP Protection : Enabled

Address Community Events Type Retry Timeout

--------------------- --------- -------- ---- ----- -------

15.29.17.218 public All trap 3 15

15.29.17.219 public Critical trap 3 15

2620:0000:0260:0211

:0217:a4ff:feff:1f70

marker Critical trap 3 15

Excluded MIBs

Snmp Response Pdu Source-IP Information

Selection Policy : rfc1517

An IPv6 address is displayed on two lines.

The show snmpv3 targetaddress command displays the configuration (including the IPv4 or

IPv6 address) of the SNMPv3 management stations to which notification messages are sent.

50 IPv6 Management Features