KB.15.15

Example 217 Viewing show qinq output (QinQ S-VLAN mode)

HP Switch(config)#: show qinq

QinQ Global Configuration:

-----------------------------------------------

Bridge-mode : svlan bridge

QinQ Interface Configuration:

--------------------------------------------------

interface port-type

--------- ----------

A1 provider-network

A2 provider-network

Trk1 customer-network

Viewing a switch VLAN configuration

The following show commands are a subset of those listed in the chapter on Static Virtual LANs

(VLANs) highlighting the changes made to show the additional QinQ VLAN types (C-VLANs and

S-VLANs).

The show vlans command lists the VLANs currently running in the switch, including the VID,

VLAN name, and VLAN status. Once QinQ is enabled in mixed VLAN mode, an additional field

showing the VLAN type is added to the display output.

Syntax:

show vlans

Changes to parameters when QinQ is enabled:

VLAN ID Field name changes from 802.1Q VLAN ID to VLAN ID only.

Type In a QinQ mixed mode environment, the VLAN type can be either a

regular customer VLAN CVLAN, or it can be a tunnel VLAN in the

provider network S-VLAN.

Figure 80 Viewing show vlans command output with QinQ disabled

Viewing the configuration for a particular VLAN

This command uses the VID to identify and display the data for a specific VLAN. Once QinQ is

enabled in mixed VLAN mode, an additional field showing the VLAN type is added to the display

output.

Syntax:

show vlans vlan-id

Viewing a switch VLAN configuration 331