Advanced Traffic Management Guide K/KA/KB.15.15

Example 226 Statistical output for a policy with active redirects
HP Switch(vlan-111)#: show statistics policy TCP_UDP vlan 111 in
HitCounts for Policy TCP_UDP
Total
100 class ipv4 TCP action
( 0 ) 10 match tcp 10.0.8.1 0.0.0.255 15.29.16.104 0.0.0.255 eq 80
( 0 ) 20 match tcp 10.0.8.1 0.0.0.255 15.29.16.104 0.0.0.255 eq 22
( 0 ) 30 match tcp 10.0.8.1 0.0.0.255 15.29.16.104 0.0.0.255 eq 23
110 class ipv4 voice action
( 0 ) 10 match tcp 10.0.8.1 0.0.0.255 15.29.16.104 0.0.0.255 eq 80
Configuring class-based zones
Zone class-based software configuration consists of the following general steps:
1. Identify the traffic that you want the HP 8200zl or 5400zl switch to intercept and forward to
the ONE application. Specifically, you need to know:
• Source
• Which users or devices are sending the traffic that you want the switch to intercept?
• Which switch ports are connected to these users' workstations and devices?
• Destination
• What is the destination of the traffic?
Based on the answers to these questions, you can begin to plan your zones and
zone policies.
2. Create a zone class.
A zone class is a logical group of switch ports. For example, you might create an
internal zone and assign all the ports on the internal network to this zone. You might
then create an external zone and assign the switch port that connects to the firewall
or router to this zone
3. Configure a zone policy for one or more zone classes, including an optional, default zone
class.
A policy specifies the traffic that should be intercepted based on the source and destination
zones. Specifically, you define a zone policy by specifying:
Source zone Where the traffic you want to accelerate originates.
Destination zone Where the traffic will be sent.
Intercept rules Define the action the switch will take—intercepting the traffic—and
the direction of the traffic. For Transparent Mode, traffic is
unidirectional, or one way.
A zone policy can contain one or more intercept rules.
4. Associate the policy with the ONE application.
364 Classifier-based software configuration