KB.15.15

NOTE: Check the release notes for the switch software you are using to ensure it supports the

ONE application that is running on your AllianceONE Extended Services zl Module.

You will configure Transparent Mode commands only when your ONE application supports this

functionality.

Troubleshooting problems

If you experience problems with your Transparent Mode configuration but cannot pinpoint the

cause, you can use the following command to gather detailed information about your Transparent

Mode configuration:

HP Switch#: show tech transparentmode

The output from this command is displayed on your terminal emulator. However, using your terminal

emulator's text capture features, you can save show tech transparentmode data to a text

file for viewing, printing, or sending to an associate or even HP Support. For example, if your

terminal emulator is the HyperTerminal application available with Microsoft® Windows® software,

you can copy the show tech transparentmode to a file and then use either Microsoft Word

or Notepad to display the data. (In this case, Microsoft Word provides the data in an easier-to-read

format.)

Where to go from here

Zone service policies are designed to work with ONE applications that support Transparent Mode.

(ONE applications run on HP AllianceONE Extended Services zl Modules.) See the ONE

application's documentation for detailed information on how to configure zone classes and zone

policies.

374 Classifier-based software configuration