HP 5400R zl2 Installation and Getting Started Guide

2-15
Installing the HP 5400R zl2 Switches
Installation Procedures
Installing the HP 5400R zl2
Switches
1. Connect the power cord supplied with the switch to the power connector
on the back of the switch, and then into a properly grounded electrical
outlet.
Connect power
cord to power
connector
Figure 2-4. Power connector on back of switch
Note The 5400R zl2 switches do not have a power switch. They are powered on
when the power cord is connected to the switch and to a power source.
If your installation requires a different power cord than the one supplied with
the switch, see the “Installation Precautions” on page 2-7.
2. Check the LEDs on the switch and on each of the switch modules. The
LED behavior is described on the next page.