HP 5400R zl2 Installation and Getting Started Guide

2-16
Installing the HP 5400R zl2 Switches
Installation Procedures
Installing the HP 5400R zl2
Switches
If the LED display is different than what is described, especially if the
Fault LED stays on for more than approximately 120 seconds or it starts
blinking, the self test has not completed correctly. See chapter 4,
“Troubleshooting” for diagnostic help.
Figure 2-5. Switch Fault, Module, and Chassis LEDs
1 Switch Fault LED
2 Switch Module LEDs: Link and Mode LEDs for each port
3 Switch Chassis LEDs
When the switch is powered on, it performs its diagnostic self test. The entire
download, initialization, and self test process can take up to 2 minutes for a
fully loaded chassis, depending on the number and type of modules installed
in the switch.
LED Behavior:
During the self test:
■ Initially, Power, Fault, Locator,and all the switch chassisLEDs are on. Then,
after approximately 30 seconds, all the module LEDs go on as the modules
receive power and code is downloaded to them, the Fault LED goes off,
and the chassis LEDs turn orange and then go off except Test, Fan, and
Power, which turn green.