HP 5400R zl2 Installation and Getting Started Guide

4-5
Replacing Components
Replacing the Management Module
Replacing Components
2. Install the new fan tray assembly and tighten the retaining screws.
Retaining Screws
Handle
Retaining Screws
Figure 4-3. 5406R zl2 Switch Fan Tray removal
Handle
Figure 4-4. 5406R zl2 Switch Fan Tray insertion
Replacing the Management Module
The switch does not have to be powered off to remove the management
module, however, when the management module is removed all ports will lose
communication. HP networking recommends replacing all components
during the scheduled down time.
To install (or replace) a Management Module:
1. On the module, unscrew the retaining screws enough to disconnect them
from the threaded holes in the switch.
2. Using the extractor handles, pull the module out from the slot.
3. Remove the flash disk from the failed module and install it into the
replacement module.
4. Remove the battery from the failed module and dispose of properly.
5. Install the new battery that came with the replacement module. See
“Installing a Management Module Battery” on page 2-10 for instructions.
6. Install the replacement module into the switch.