KB.15.15

Example 149 Output for show ipv6 ospf3

HP Switch# show ipv6 ospf3

OSPFv3 Configuration Information

OSPFv3 Protocol : Enabled

Router ID : 10.0.8.35

Currently defined areas:

Stub Stub Stub

Area ID Type Default Cost Summary LSA Metric Type SPF Runs

--------- ------ ------------ ----------- ------------- --------

backbone Normal 1 don’t send Ospfv3 Metric

10.3.16.0 Normal 1 don’t send Ospfv3 Metric

10.3.32.0 Normal 1 don’t send Ospfv3 Metric

Currently defined address ranges:

Prefix

AreaID LSAType Advt IPv6Addr

--------------- ---------- ------ --------------

OSPFv3 interface configuration:

Admin

Interface Area ID Status Type Cost Pri

---------- --------------- -------- ----- ----- ---

vlan-55 0.0.0.1 Enabled BCAST 1 1

vlan-75 0.0.0.1 Enabled BCAST 1 1

tunnel-3 0.0.0.0 Enabled P2P 1 1

OSPFv3 configured interface timers:

Transit Retransmit Hello Dead

Interface Delay Interval Interval Interval

---------- ------- ---------- -------- ----------

vlan-55 1 5 10 40

VLAN-75 1 5 10 40

tunnel-3 1 5 10 40

OSPFv3 configured virtual interfaces:

Xmit Rxmt Hello Dead

Transit AreaID Neighbor Router Delay Intvl Intvl Interval

--------------- --------------- ----- ----- ----- ----------

0.0.0.1 15.255.155.1 1 5 10 40

Viewing general OSPFv3 configuration information

230 OSPFv3 Routing