KB.15.15

Example 51 Configuring the current MLD

The general form of the command might look like this:

HP Switch# show ipv6 mld config

MLD Service Config

Control Unknown Multicast : Yes

Forced Fast Leave Timeout (deci-seconds) : 4 deci-seconds

VLAN ID VLAN NAME MLD Enabled Querier Allowed MLD Version

------- ---------- ----------- --------------- -----------

8 VLAN8 Yes Yes 2

9 VLAN9 Yes Yes 1

Listing ports currently joined

Syntax:

show ipv6 mld vlan vid group

Lists the ports currently joined for all IPv6 multicast group addresses in the specified

VLAN.

vid

VLAN ID

show ipv6 mld vlan vid group ipv6-addr

Lists the ports currently joined for the specified IPv6 multicast group address in the

specified VLAN.

vid

VLAN ID

ipv6-addr

address of the IPv6 multicast group for which you want information.

show ipv6 mld vlan vid group port-num

Shows a list of all the MLD groups on the specified port.

show ipv6 mld vlan vid group ipv6-addr source ipv6-addr

Only for MLDv2. Specify the source IPv6 address.

Listing ports currently joined 75