Multicast and Routing Guide K/KA/KB.15.15

MeaningMessage
The group prefix needs a route/mask entry. For example,
if you want, 224.x.x.x/4, you input 224.0.0.0/4.
Inconsistent address and mask
Received a packet from the indicated IP address and VLAN,
and dropped it.
Pkt dropped from ip-addr reason, vid
vid-#
A packet arrived from the indicated IP address with a
checksum error.
Pkt rcvd with a cksum error from ip-addr
There was an error regarding the PIM socket, either on a
sockopt call or a recvfrom call.
PIM socket error
Received a packet from the indicated IP address with the
wrong PIM version number.
Rcvd pkt ver# # , from ip-addr ,expected
#
Unknown PIM packet type received from the indicated IP
address.
Rcvd pkt from rtr ip-addr , unkwn pkt type
pkt-type
A misconfiguration exists between the routers.
Rcvd hello from ip-addr on vid vid-#
An incorrect hello packet was received from the indicated
IP address.
Rcvd incorrect hello from ip-addr
A PIM packet with an unknown option number was
received from the indicated IP address.
Rcvd unkwn opt # in pkt-type pkt from
ip-addr
A PIM packet with an unknown address family was
received.
Rcvd unkwn addr fmly add-family in pkt-type
pkt from ip-addr
A PIM packet with an inconsistent length was received from
the indicated IP address.
Rcvd pkt-type pkt with bad len from
ip-addr
Send packet failed on the indicated VLAN.
Send error( error-# ) on packet-type pkt
on VID vid-#
The configuration of a static RP for the indicated multicast
group has failed on the indicated interface.
Static RP configuration failure:
src-ip-addr , multicast-addr
PIM_DM could not allocate memory for the indicated buffer.
Unable to alloc a buf of size size for
memory element
Informs the user that a message buffer could not be
allocated for the indicated system event.
Unable to alloc a msg buffer for
system-event
The PIM interface has been removed due to an IP address
removal or change.
Unable to allocate table-type table
PIM received an event type in a state that was not
expected.
Unexpected state/event state /event in
statemachine statemach
A VLAN must be statically configured with a primary IP
address before enabling PIM-SM on that VLAN. If the VLAN
VLAN is not configured for IP.
has no IP address or is configured to acquire a primary IP
address by using DHCP/Bootp, it cannot be configured to
support PIM-SM.
106 PIM-SM (Sparse Mode)