Advanced Traffic Management Guide K/KA/KB.15.15

Example 206 Removing a stack member and reconfiguring
HP Stack 3800(config)#: stacking member 5 remove
The specified stack member configuration will be erased. The
resulting configuration will be saved. Continue [y/n]? Y
HP Stack 3800(config)#: stacking member 5 type J9576A mac 1cc1de-4da900
This will save the current configuration. Continue [y/n]? Y
Stack ID : 00011cc1-de4d87c0
tty=ansi HP Stack 3800(config)#: show stacking
Strictly provisioned: Mis-Matched Type
Stack ID : 00011cc1-de4d87c0
MAC Address : 1cc1de-4d87e5
Stack Topology : Mesh
Stack Status : Active
Uptime : 4d 0h 35m
Software Version : KA.15.05.0000x
Mbr
ID Mac Address Model Pri Status
--- ------------- ------------------------------------- --- ---------------
1 1cc1de-4d87c0 HP J9573A 3800-24G-PoE+-2SFP+ Switch 128 Commander
2 1cc1de-4dc740 HP J9573A 3800-24G-PoE+-2SFP+ Switch 128 Standby
3 1cc1de-4dbd40 HP J9575A 3800-24G-2SFP+ Switch 128 Member
4 1cc1de-4d79c0 HP J9576A 3800-48G-4SFP+ Switch 175 Member
5 1cc1de-4da900 HP J9576A 3800-48G-4SFP+ Switch 128 Not Joined
Boot the switch with the matching MAC/Type.
Example 207 Viewing joined stack members
HP Stack 3800(config)#: show stacking
Stack ID : 00011cc1-de4d87c0
MAC Address : 1cc1de-4d87e5
Stack Topology : Mesh
Stack Status : Active
Uptime : 4d 0h 50m
Software Version : KA.15.05.0000x
Mbr
ID Mac Address Model Pri Status
--- ------------- ------------------------------------- --- ----------------
1 1cc1de-4d87c0 HP J9573A 3800-24G-PoE+-2SFP+ Switch 128 Commander
2 1cc1de-4dc740 HP J9573A 3800-24G-PoE+-2SFP+ Switch 128 Standby
3 1cc1de-4dbd40 HP J9575A 3800-24G-2SFP+ Switch 128 Member
4 1cc1de-4d79c0 HP J9576A 3800-48G-4SFP+ Switch 175 Member
5 1cc1de-4da900 HP J9576A 3800-48G-4SFP+ Switch 128 Member
Troubleshooting maximum stack members exceeded
This failure can happen if you have an active stack that has already reached its maximum number
of members. It can also happen when the maximum number of switches is reached with a
combination of active members and strictly provisioned members.
Since one of the suggested initial deployment techniques is a deterministic method using strictly
provisioned entries, this failure example demonstrates what occurs if the maximum number of
members is reached by strictly provisioning ten members. At least one of these configuration entries
has an incorrect MAC addresses. Similar to the mismatched MAC address example, the stack
312 Stack management for the 3800 switches