HP 5400R zl2 Installation and Getting Started Guide

2-14
Installing the HP 5400R zl2 Switches
Installation Procedures
Installing the HP 5400R zl2
Switches
For installation details, see the instructions in the manual that comes with the
power supply.
Insert the power supply into
the opening, then slide it all
the way in until it connects
to the switch. The power
supply face plate will be
flush with the back face of
the switch.
Figure 2-3. Installing a power supply
1 Handle to insert the power supply into the Chassis.
2 Screws
Once the power supply is installed, tighten the four retaining screws that hold
it in place. The screws can be tightened with either a flat-bladed or Torx T-10
screwdriver. Be careful not to overtighten the screws.
4. Verify the Switch Passes Self Test
After you have installed any modules and the optional second power supply,
but before mounting the switch in its network location, you should first verify
it is working properly by plugging it into a power source and verifying it passes
its self test.
If you have installed a second power supply, repeat these procedures with the
second power supply to verify it works correctly also.