HP 5400R zl2 Installation and Getting Started Guide

4-6
Replacing Components
Replacing the Management Module SD Card
Replacing Components
7. Use an equal amount of pressure and push both extractor handles closed
to completely seat the module.
8. Tighten the retaining screws
.
Figure 4-5.
1 Management Module
2 Extractor handles
3 Retaining screws
Management Module removal and installation
You can use MM Shutdown buton to replace an active Management Module.
This helps the standby MM to become active.
Replacing the Management Module SD
Card
The SD card is the primary non-volatile storage medium located on the
management module that contains both the boot software and configuration
files. When a SD card fails, the SD status LED on the management module