WB 15.15

Enable LACP

Trying to enable LACP while OpenFlow is enabled generates the following error message.

LACP cannot be configured when OpenFlow is enabled.

Enable OpenFlow

Trying to enable OpenFlow when LACP is enabled generates the following error message.

OpenFlow cannot be configured when LACP is enabled.

Show per-flow rate limiters

Trying to show per-flow rate limiters for an instance running OpenFlow version 1.3 generates an

error message similar to the following.

This command is supported only for an OpenFlow version 1.0

instance.

no allow-v1–module

Trying to run the command [no] allow-v1-module when OpenFlow is enabled generates an

error message similar to the following.

V1 modules cannot be disabled when OpenFlow is enabled.

allow-v1–module

Trying to run the command allow-v1-module when OpenFlow is enabled generates an error

message similar to the following.

V1 modules cannot be enabled when IP Control Table Mode is

enabled.

Non-compatible mode

Trying to enable OpenFlow when a switch is in a non-compatible mode ( no allow-v1–module)

generates an error message similar to the following.

OpenFlow cannot be enabled when V1 modules are disabled.

Enable virus throttling

Trying to enable virus throttling when OpenFlow is enabled generates an error message similar to

the following.

Virus throtting cannot be enabled when OpenFlow is enabled.

Enable OpenFlow with virus throttling

Trying to enable OpenFlow when virus throttling is enabled generates an error message similar to

the following.

OpenFlow cannot be configured when virus throttling is

enabled.

Controller error messages

Deleting an unconfigured controller

Attempt to delete a controller that has not been configured will result in an error message similar

to the following.

HP-8206zl(vlan-3)# no openflow controller-id 2

[controller-id] 2 not found.

52 Troubleshooting OpenFlow