WB 15.15

Other scenarios

Setting policy engine resource usage when OpenFlow is enabled

When the policy engine resource usage is set while OpenFlow is enabled, will display an error

message similar to the following.

Resource usage can be set only when OpenFlow is disabled.

Securing a connection with no certificate configured

When securing a connection with no certificate configured for OpenFlow, will display an error

message similar to the following.

Certificate for OpenFlow is not configured.

Setting the protocol version with instances enabled

Setting the protocol version when instances are enabled will display a message similar to the

following.

Instance configuration cannot be modified when the instance

is enabled.

Entering the wrong protocol version

Entering the wrong protocol version will display an error message similar to the following.

Entering the wrong protocol version will display an error

message similar to the following.

Troubleshooting scenarios for instances

Troubleshooting an instance

To troubleshoot instances, check the following.

• To connect a controller there must be ip-connectivity between controller and switch over the

controller VLAN.

• The controller must be capable of negotiating to a version equal to or less than the configured

or supported version.

• Use the show openflow command to check instances

Example

HP-Stack-3800(config)# show openflow

OpenFlow : Enabled

IP Control Table Mode : Disabled

Instance Information

No. of No. of OpenFlow

Instance Name Oper.Status H/W Flows S/W Flows Version

----------------- ------------ --------- ---------- ----------

test Down 0 0 1.0

• Use the show openflow instance [instance-name] command

Example

HP-Stack-3800(config)# show openflow instance test

Configured OF Version : 1.0

Negotiated OF Version : 1.0

Instance Name : test

Admin. Status : Enabled

Member List : VLAN 3

Listen Port : 6677

Oper. Status : Down

Oper. Status Reason : NA

Error messages 57