HP OpenFlow 1.3 Administrator Guide Wired Switches K/KA/KB/WB 15.15

Datapath ID : 0003082e5f698e25
Mode : Active
Flow Location : Hardware and Software
No. of Hw Flows : 0
No. of Sw Flows : 0
Hw. Rate Limit : 0 kbps
Sw. Rate Limit : 100 pps
Conn. Interrupt Mode : Fail-Secure
Maximum Backoff Interval : 60 seconds
Probe Interval : 10 seconds
Hw. Table Miss Count : 0
No. of Sw Flow Tables : NA
Egress Only Ports : None
Table Model : Single Table
Controller Id Connection Status Connection State Secure Role
------------- ----------------- ---------------- ------ ------
1 Disconnected Backoff No Equal
Commands issued from listen port or controllers are not successful
When commands issued from the listen port or the controller are not successful, the following
commands can be used to isolate and troubleshoot the problem.
Syntax
show openflow instance [instance-name] flow-table [table#]
table-capabilities
To display the table-capabilities of the instance in OpenFlow 1.3.
Syntax
show vlan [member-vlan-no]
To display the port-description.
Syntax
show openflow instance [instance-name]
To see egress-only ports.
Syntax
show openflow instance [instance-name]port-statistics
To display port statistics.
Syntax
show openflow instance [instance-name] meters [number]
To display the meter statistics.
Syntax
show openflow instance [instance-name]groups
To display groups.
Connection interruption mode setting
For minimal impact to an underlying network when a switch loses connection to the controller, the
recommended setting is fail-standalone mode.
58 Troubleshooting OpenFlow