HP Switch zl2 Internal Power Supplies Installation Guide Power over Ethernet
HP Switch zl2 Internal Power Supplies Installation Guide
© Copyright 2005-2012, 2014 Hewlett-Packard Development Company, L.P.
Contents Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Included Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Installing the Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Installation Cautions: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Installation Steps . . . . . . . . . . . . . . . . .
iv
Description HP Switch zl2 Internal Power Supplies Description The HP Switch zl2 Internal Power Supplies (J9828A, J9829A or J9830A) are redundant power supplies that you can add to any of the HP zl2 switches to provide additional switch reliability. Features: ■ Power redundancy—if any one of the power supplies should fail, the remaining supply or supplies provide the power to continue running a fully loaded 5400R zl2 switch.
Description 2 Figure 1. The J9828A PoE Power Supply Figure 2.
Description Figure 3.
Description ■ Power cord, one of the following: Country/Region Australia/New Zealand China Mainland Europe/South Korea India Japan/Thailand Denmark/Switzerland United Kingdom/Hong Kong/Singapore/ Malaysia United States/Canada 125V South Africa Taiwan/USA 250V Israel Argentina Brazil Chile J9830A Power Supply Cable 8121-1550 8121-1551 8121-1554 8121-1074 8121-15551 8121-1287 8121-1549 8121-1553 8121-1552 8120-63622 8121-1010 8121-0925 8121-1101 8121-0923 1 Japan: NEMA 6-20P, 200V. 2 Taiwan/U.S.A.
Description Country/Region Australia China Europe/South Korea Japan Thailand/Philippines India Denmark Switzerland United Kingdom/Hong Kong/Singapore/ Malaysia South Africa Taiwan Israel Argentina Brazil Chile USA/Canada J9828A Power Supply Cable 8121-0834 8120-8707 8120-6811 8120-4753 8121-0668 8121-0780 8120-6814 8120-6815 8120-6809 8120-6813 8121-0974 8121-1035 8120-6869 8121-1069 8120-6980 8121-0914 Japan Power Cord Warning 5
Installing the Power Supply Installing the Power Supply Installation Cautions: ■ When installing multiple power supplies for a switch, use the same power supply type. ■ Make sure the power source circuits are properly grounded, then use the power cord supplied with the power supply to connect it to the power source. If your installation requires a different power cord than the one supplied with the power supply, be sure the cord is adequately sized for the switch’s current requirements.
Installing the Power Supply Installation Steps Follow these steps to install the power supply into the back of the switch: 1. Caution Remove the power supply slot cover with either a flat-bladed or Torx T-10 screwdriver. Retain the slot cover for future use. Make sure the AC power is not connected to the power supply being installed before installing the power supply into the switch. The switch can be receiving power from the other power supply during the installation of the second unit. 2.
Installing the Power Supply Note During the installation, make sure that AC power is NOT connected to the unit being installed. Note Although the illustration shows an HP 5406R zl2 switch, the installation procedure is the same for all zl2 switches. 3. Tighten the four retaining screws that hold the power supply in place until the screws are secure, as shown in the next illustration. The screws can be tightened with either a flat-bladed or Torx T-10 screwdriver.
Installing the Power Supply source fails, the switch will continue to run. Using a twisty, secure the power cord to the plug handle to prevent the power cord from accidentally disconnecting from the Power Supply. Note The Switch zl2 Internal Power Supply does not have a power switch. It is powered ON when the power cord is connected to the supply and to a power source. Please see the “Installation Cautions” on page 6. 6.
Installing the Power Supply 7. Verify the power supply is installed correctly by checking the LEDs on the front of the switch. The following example shows an 5406R zl2 switch. Figure 7. Switch Power Status and Fault LEDs The status LED for the power supply, on the management module bulkhead, you have just installed will be flashing simultaneously with the Fault LED until that new power supply is connected to an AC power source.
Troubleshooting Troubleshooting If the Power Status LED and the switch Fault LED are flashing, either the power supply is not connected to an active AC power source, the power supply is not properly installed, or a fault condition has been detected on the power supply. Caution 1. Verify the power cord is plugged into an active power source and to the power supply. Make sure these connections are secure.
Specifications Specifications Physical Power Supply: Weight J9828A 2.44 kg (5.38 lbs) J9829A 2.74 kg (6.03 lbs) J9830A 4.19 kg (9.23 lbs) J9828A, J9829A, J9830A Width: 18.92 cm (7.45 in) Depth: 15.87 cm (6.25 in) Height: 12.95 cm (5.1 in) Electrical The HP zl2 Internal Power Supplies automatically adjust to any voltage between 100-127 and 200-240 volts and either 50 or 60 Hz.
Specifications Environmental Operating Non-Operating Temperature: 0°C to 45°C (32°F to 113°F) -40°C to 70°C (-40°F to 158°F) Relative humidity: (non-condensing) 15% to 85% at 40°C (104°F) 15% to 90% at 65°C (149°F) J9828A 3.0 km (10,000 ft) 4.6 km (15,000 ft) J9829A 3.0 km (10,000 ft) 4.6 km (15,000 ft) J9830A 3.0 km (10,000 ft) 4.6 km (15,000 ft) 1 Maximum altitude: 1 Operating ambient temperature is limited to 40°C (104°F) under certain configurations.
Safety Information Safety Information ! Documentation reference symbol. If the product is marked with this symbol, refer to the product documentation to get more information about the product. WARNING A WARNING in the manual denotes a hazard that can cause injury or death. Caution A Caution in the manual denotes a hazard that can damage equipment. Do not proceed beyond a WARNING or Caution notice until you have understood the hazardous conditions and have taken appropriate steps.
Informations concernant la sécurité Informations concernant la sécurité ! Symbole de référence à la documentation. Si le produit est marqué de ce symbole, reportez-vous à la documentation du produit afin d'obtenir des informations plus détaillées. WARNING Dans la documentation, un WARNING indique un danger susceptible d'entraîner des dommages corporels ou la mort. Caution Un texte de mise en garde intitulé Caution indique un danger susceptible de causer des dommages à l'équipement.
Hinweise zur Sicherheit Hinweise zur Sicherheit ! Symbol für Dokumentationsverweis. Wenn das Produkt mit diesem Symbol markiert ist, schlagen Sie bitte in der Produktdokumentation nach, um mehr Informationen über das Produkt zu erhalten. WARNING Symbol für Dokumentationsverweis. Wenn das Produkt mit diesem Symbol markiert ist, schlagen Sie bitte in der Produktdokumentation nach, um mehr Informationen über das Produkt zu erhalten. Caution Symbol für Dokumentationsverweis.
Considerazioni sulla sicurezza Considerazioni sulla sicurezza ! Simbolo di riferimento alla documentazione. Se il prodotto è contrassegnato da questo simbolo, fare riferimento alla documentazione sul prodotto per ulteriori informazioni su di esso. WARNING La dicitura WARNINGdenota un pericolo che può causare lesioni o morte. Caution La dicituraCaution denota un pericolo che può danneggiare le attrezzature.
Consideraciones sobre seguridad Consideraciones sobre seguridad ! Símbolo de referencia a la documentación. Si el producto va marcado con este símbolo, consultar la documentación del producto a fin de obtener mayor información sobre el producto. WARNING Una WARNING en la documentación señala un riesgo que podría resultar en lesiones o la muerte. Caution Una Caution en la documentación señala un riesgo que podría resultar en averías al equipo.
Safety Information (Japan) Safety Information (Japan) Japan Power Cord Warning 19
Safety Information (China) Safety Information (China) 20
EMC Regulatory Statements EMC Regulatory Statements U.S.A. FCC Class A This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against interference when the equipment is operated in a commercial environment.
EMC Regulatory Statements Korea Taiwan 22
Recycle Statements Recycle Statements Waste Electrical and Electronic Equipment (WEEE) Statements Disposal of Waste Equipment by Users in Private Household in the European Union This symbol on the product or on its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment.
Recycle Statements Laitteiden hävittäminen kotitalouksissa Euroopan unionin alueella Jos tuotteessa tai sen pakkauksessa on tämä merkki, tuotetta ei saa hävittää kotitalousjätteiden mukana. Tällöin hävitettävä laite on toimitettava sähkölaitteiden ja elektronisten laitteiden kierrätyspisteeseen. Hävitettävien laitteiden erillinen käsittely ja kierrätys auttavat säästämään luonnonvaroja ja varmistamaan, että laite kierrätetään tavalla, joka estää terveyshaitat ja suojelee luontoa.
Recycle Statements Smaltimento delle apparecchiature da parte di privati nel territorio dell'Unione Europea Questo simbolo presente sul prodotto o sulla sua confezione indica che il prodotto non può essere smaltito insieme ai rifiuti domestici. È responsabilità dell'utente smaltire le apparecchiature consegnandole presso un punto di raccolta designato al riciclo e allo smaltimento di apparecchiature elettriche ed elettroniche.
Recycle Statements Descarte de Lixo Elétrico na Comunidade Européia Este símbolo encontrado no produto ou na embalagem indica que o produto não deve ser descartado no lixo doméstico comum. É responsabilidade do cliente descartar o material usado (lixo elétrico), encaminhando-o para um ponto de coleta para reciclagem.
Regulatory Regulatory European Community China Regulatory ᳝↦ǃ᳝ᆇ⠽䋼/ܗ㋴ঞ݊䞣㸼 DECLARATION OF CONFORMITY according to ISO/IEC 17050-1 and EN 17050-1 DoC #: RSVLC-1301-R1 Supplier's Name: Supplier's Address: Hewlett-Packard Company 8000 Foothills Blvd., Roseville, CA 95747 U.S.A.
Regulatory 28
Technology for better business outcomes To learn more, visit www.hp.com/networking © Copyright 2005-2012,2014 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty.
